No products in the cart.
Wiergate
Participant
Topics Started: 1
Replies Created: 4
Has Thanked: 1
Been Thanked: 0
I have to admit I wouldn’t have guessed it’s based on a Distressor, so it would be stretching a bit to assume that’s why I liked it in the first place.
I do have the UAD plugin and use it often, would be interesting to see how its modes/ratios were translated to the SD3 plug. (I frankly prefer to think of them more as modes given the high variability and program-dependency beyond the bounds of a ratio.)
An interesting surprise in any case, thanks Olof and everyone.
Thanks for the thoughtful replies, all. Perhaps this Olof (one of the devs?) can help out of they see this, otherwise I have a couple of leads at least.
Please share those leads as any info would help us all and give us something to look at.
Reply To: Classic Compressor in SD3? version: 3.3.7
Operating system: macOS High Sierra (10.13)
Jord called it, what I’ve heard from the respondents in this thread are indeed my leads thus far. If I should think of or hear anything more I’ll be sure to update.
Thanks for the thoughtful replies, all. Perhaps this Olof (one of the devs?) can help out of they see this, otherwise I have a couple of leads at least.
Googling this issue lead me to this thread. It was started in September 2017. This is October 2023.
I’m at a loss for words.
None of the above suggestions worked. A narrow sliver of each of what could be two buttons can be seen where the installer window chops them off.
I’ve set the file path; in theory the rightmost one might say ‘install’. If I need to make some other decision, however, and it’s not the install button…
How do I get the SDX installer to display without being truncated so I know for certain which paths and which settings I’m agreeing to when installing this (very expensive) piece of software?
No products in the cart.