Please help with sample volumes

E-drum Workshop
Viewing 3 replies - 1 through 3 (of 3 total)
  • Henrik
    Participant

    Have you tried to change velocity curve for tom 2? You can set the curve so that you don’t have to hit your e-drum that hard to produce a loud hit from Superior Drummer 2.¨
    Drag the right handle left (as shown in screenshot, right lower corner). It’s found in the Mapping tab (on the top of the screenshot, also marked in a red ring).mapping.png

    Henrik Ekblom - User Experience Designer
    Toontrack

    Mark Juliano
    Participant

    @Henrik said:

    Have you tried to change velocity curve for tom 2? You can set the curve so that you don’t have to hit your e-drum that hard to produce a loud hit from Superior Drummer 2.¨
    Drag the right handle left (as shown in screenshot, right lower corner). It’s found in the Mapping tab (on the top of the screenshot, also marked in a red ring).mapping.png

    Thanks so much man I did think about that but I don’t want to change the dynamicscurve I want to keep it as default as possible just louder volume. Its a tricky one.

    Mark Juliano
    Participant

    i fixed the volume of the low floor tom or floor toms both had the same issue just floor tom 2 was worse. it was the default stereo panning in sd2. i run line/mono out to a loud speaker so all my channel pans had to be set all the way to the left to get the most volume out of the speaker.

Viewing 3 replies - 1 through 3 (of 3 total)

Please log in to read and reply to this topic.

No products in the cart.

×