I am evaluating the Demo version of EZ Drummer 2 with my TD-1KV kit. I finally got it working with a USB cable from the Roland Module into my laptop with 8GB RAM, i7 processor and the latest drivers for its RealTek HD audio card (I know, right?). My latency was a mess until I got the ASIO4all driver installed, now I get 5 to 9 msec in and out which is fine (I was getting 120msec out with just the regular drivers, ugh). The sounds are quite an upgrade, but I noticed an issue. I noticed that I am not getting/hearing the bell sound on the ride like I do with the drum module. I get the ride and the edge sounds but not the bell.
Kickass Torrent Unblocked Websites Get Free Netflix Cookies Working 1337x Torrent Unblocked Websites Top Rated Dash Cams On Amazon
I know SD2.0 gives you more options, but I was wondering if it’s possible to change the triggering from the kit. I didn’t see any mapping screens inside of EZD2, just the midi device which reads TD1K. I couldn’t find anything in searching these forums about mapping with the TD1-Kx.
Also another potentially dumb question, but since I am listening to the kit through headphones in the laptop, I cannot play along to music as I can through the module. I expect that has to do with the ASIO4all driver being in use for sound. Is there a setting I am missing to have say, Spotify, playing/using the same audio driver? I suspect the fact that ASIO is taking exclusive control of the sound is what drives the latency so low, so is there a lo-tech or hardware way around this?
