ORIGINAL: flipotto

Hey Jman,
I am still working with the sensitivity..
However, I did move the large piezo to the outside of the box, about an inch from the edge of the bottom of the ecymbal.
It is working pretty good, I still need to get used to when the edge will trigger.
Also the jack inside there is very very cheap… I had to repair that is several places, I really need to just buy a new jack, and get rid of the circuit board.

From the looks of it you should be able to do that fairly easily. That’s a pretty small area to get the triggers to work separately. Hope you get it dialed in. The larger piezo will usually be more sensitive than the smaller ones, so I would put that on the location that you will be striking most often. You should be able to remove that jack from the board and solder your wires directly to it.

Jman