Topic: Cymbals getting Choked | Toontrack

Cymbals getting Choked

Studio Corner

Posted December 7, 2010 at 17:25 #1893445

engineerjoel
Participant

ezdrummer v 1.2.1

When I play (audition) the cymbals via the drum-set GUI, the two crash cymbals ring out for along time. But, when I manually enter a Cymbal Note in the midi sequence, the cymbal only plays for a very short duration and then chokes down. What’s causing this? What’s the fix for this?

thanks,
Creator

Topic

Viewing 3 replies - 1 through 3 (of 3 total)

Replied February 2, 2011 at 22:28 #1945388

Judson Crane
Participant

any answers for this?? for the life of me I can’t figure it out. I’ve basically not used any of the cymbals from SD 2.0 since I purchased it. thanks for any help.

Replied February 2, 2011 at 22:39 #1945390

Judson Crane
Participant

ok, figured it out….turn off the envelope for the instrument (cymbal) OR set it to note off and make sure your midi note is as long as you want your sustain to be.

Replied November 8, 2021 at 22:01 #2811907

davideaston
Participant

So I tried Judson’s remedy and got very excited because it made sense…but unfortunately it didn’t change anything. Still the cymbal was getting choked.

I then however found that when I looked to the right of where you select the cymbal/instrument, you can also find which articulations are loaded. For me, both “Crash” and “mute Hit” were loaded. I deactivated “Mute Hit” and voila the cymbal sustained!
Author

Replies

Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Please log in to read and reply to this topic.

< previous

> next

0:00

0:00

volume

×